MATCH LIGHTING THE MAIN BURNERS:
1 . Open lid before lighting .
2 . Make sure all control knobs are in the “OFF” position .
3 . Place a paper match in the end of the matchlighter . Strike the match
and place through lighting hole in the left hand side of the grill to
approximately 1/2” (1 to 2 cm) from the burner.
4 . Turn on the
FAR LEFT
burner control knob to the “HIGH” position .
The burner should light within 5 seconds .
5 . If the burner does not light, turn the control knob to “OFF” and wait
5 minutes for gas to dissipate and repeat lighting procedure .
6 . Once lit, light adjacent burners in sequence by pressing in and
rotating the control knob to the “HIGH” position .
7 . If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply . Turn off the gas at the burner
and
cylinder .
DO NOT
attempt to operate the grill until the
problem is found and corrected .
Note: If burner does not light or flame is too low, See “Trouble Shooting” section of the owners
manual .
LIGHTING THE SIDE BURNER:
1 . Open lid before lighting side burner .
2 . Make sure control knob is in the “OFF” position .
3 . Push and hold down side burner control knob and SLOWLY
(2 to 3 seconds) turn to “HIGH” . You should hear the igniter click .
Note: Step 3 may need to be repeated 2-3 times to light side burner .
4 . If ignition does NOT occur in 5 seconds, turn control knob to “OFF”, wait
5 minutes to allow gas to dissipate and repeat lighting procedure .
5 . If burner does not ignite using the igniter, see “Match Lighting the Side
Burner” section .
6 . To turn off, turn control knob clockwise until it locks in “OFF” position .
Note: If burner does not light or flame is too low, See “Trouble Shooting”
section of the owners manual .
MATCH LIGHTING THE SIDE BURNER:
1 . Open the lid to the side burner before lighting .
2 . Turn the burner control knob to “OFF” .
3. Strike and carefully place a match approximately 1/2” (1 to 2 cm) from the burner.
4 . Turn the side burner control knob to the “HIGH” position . The burner should light within 5 seconds .
5 . If the burner does not light, turn the control knob to “OFF” and wait 5 minutes for gas to dissipate and
repeat lighting procedure .
6 . If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply . Turn off the gas at the burner
and
cylinder .
DO NOT
attempt
to operate the grill until the problem is found and corrected .
Note: If burner does not light or flame is too low, See “Trouble Shooting”
section of the owners manual .
Note: Observe flame height when lit: Flame should be a Blue/Yellow
color between 1”–2” when burner is on “HIGH” .
See section in manual on burner adjustment to adjust flame.
10
Lighting Hole
Matchlighter
