Brink Air 70, Руководство по установке

Страница: 19 / 40

Air 70 Rev. D 15
Chapter 6 Putting into operation
Powering the
appliance
Taking the voltage
from the appliance
6.1
Powering the or taking the voltage from the appliance
- Connect the appliance to, or disconnect it from, the mains power by inserting or pulling the mains plug or, if the optional mains
switch is installed, by setting this switch to 1 or 0 respectively.
As soon as the power is turned on or if the appliance is reset to factory settings, a self-test will be performed. During this self-test,
all LEDs are blinking green simultaneously. Operating the appliance is not possible during the self-test. The self-test takes at least
4 and no more than 9 minutes. If a fault is detected during the self-test, a fault message with blinking red LEDs will appear directly
after the self-test (see §7.1).
0
1
¨ ¨
10 s.
or
Switching off the appliance for 30 minutes
Switching on the appliance within 30 minutes
0
1
¨ ¨
or
Green LEDs of set ventilation
mode light up during 10 sec-
onds and then they go out.
Green LEDs of set ventila-
tion mode blink
Fast
+
-
+
-
>5s.
Option
Option
- Switching on and off with push buttons on the appliance.
6.2 Switching the appliance on and off
+
-
+
-
+
-
>5s.
Switching off
Switching on
Green LEDs of set ventila-
tion mode blink
Slow
>10s.
>10s.
+
-
+
-
10 s.
+
-
+
-
+
-
Green LEDs of set ventilation
mode light up during 10 sec-
onds and then they go out.