Brill 61080, Руководство пользователя, Страница: 25 / 96

25
GB
The following table contains the problems most frequently occurring and shows how to remedy them.
Problem Possible cause Remedy
Abnormal noise.
Motor fixing screws or Tighten screws.
Clattering in the unit. mower casing loose.
Cutting cylinder touches Adjust or replace if damaged.
the bottom blade.
Metal-like hammering noises. Foreign body blocking the Turn off the mower.
Schlaggeräusche. cutting cylinder. Disconnect the mains plug.
Remove the foreign body.
Cutting cylinder deformed Install a new cutting cylinder .
by foreign object.
Overload clutch activated. Blocked by foreign body. Switch off the motor.
The clutch has therefore Disconnect the mains plug.
been activated. Remove the foreign body.
Clutch has been activated. First use your Electric Hand
The cutting height you have Lawnmower with a higher
selected is too low; you are cutting height, then reduce the
pushing the mower too quickly. cutting height in stages until you
Coupling/circuit breaker has reach the lower cutting height
been activated. you require.
Push the mower more slowly
across the lawn.
Yellow lawn. Cutting height too low. Increase the cutting height.
Cut not clean.
Cutting gap between cutting Readjust cutting tool (refer to
cylinder and bottom blade section 8.2.).
is too wide.
Blades are blunt or damaged. Have the blade replaced at a
Brill Service Centre or by an
authorised specialist.
10. Trouble-shooting
If you have any other problems
with your Electric Lawnmower,
please contact Brill Customer
Service or return the defective
unit with a short description of
the problem and, in case of
guarantee, with the appropriate
guarantee documents to one of
the service centres listed in this
leaflet. We would draw attention to
the fact that, under the product
liability legislation, we are not
liable for loss or damage caused
by our products when such are
caused by improper repairs or
when during an exchange of
parts such parts are used which
are not manufactured by or ap-
proved by ourselves, and the re-
pairs are not carried out by an
authorised Brill service centre or
an authorised specialist dealer.
The same restrictions also apply
for supplementary and accessory
parts.