Bright Solutions BSL1500, Руководство пользователя

Страница: 4 / 11

Operation of High Speed Floor Machine
* READ OPERATORS MANUAL
THOROUGHLY PRIOR TO OPERATING
OR SERVICING THIS MACHINE.
GENERAL USE
1. Remove any obstructions or other obstacles
in the area which is to be cleaned.
2. 2. 2. 2.
Place the handle in the upright position and
tilt machine back until handle rests on the
floor
* Be sure the machine is not plugged into
an outlet
3. Attach the pad to the machine by first
unscrewing the male end of the “big mouth”
from the flexible pad driver. Place the
approved pad on the pad driver, place the
male end of the “big mouth” into the center
hole of the pad, and tighten the “big mouth”
firmly to the pad driver.
4. Place machine back into its upright position.
5. Plug power cord into a grounded outlet.
* Never use an extension cord in
conjunction with the standard power
cord.
6. The handle height may be adjusted by lifting
up the compression handle which is located
on the right side of the handle tube about 1
foot above floor level. Release the
compression handle and adjust handle to
safe operating height, then push back down
on the compression handle to lock the
handle in operating position.
7. To start the machine, press the red safety
button on the top of the upper switch
housing, and then squeeze either of the
operating triggers. (the safety button must
be depressed prior to squeezing the
operating triggers.)
8. When the machine is in operation, both
hands should be placed on the switch
housing (upper handle).
9. To stop the machine at any time, simply
release the operating trigger(s) and the
machine will stop automatically.
MAINTENANCE
To keep the machine performing well for
many years, please follow the following
maintenance procedures.
* Always confirm that the machine is
unplugged prior to performing any
maintenance or repairs.
1. Unplug machine as soon as you are done
using it.
2. Clean the outside of the machine with a
mild cleaner.
3. Check power cord for any damage. If
damage is detected, replace power cord
immediately.
4. Lubricate wheels with a water resistant
lubricant once a month.
5. Check machine for loose or missing nuts
and bolts, and replace as necessary.
6. If the machine is used in a dusty
environment, you may remove the motor
cover and blow the motor clean with
compressed air. This will ensure proper
ventilation, and allow the motor to run
cooler.
STORAGE
1. Unplug machine from power source and
wrap cord on handle.
2. Tilt machine so the pad is not touching the
floor.
3. Store machine in upright position and in a
dry area.
-4-