Not for
Reproduction
11
ASSEMBLY
PROCEDURES
Text
Trimmer Line Assembly - Cast Alloy Head
4
3
2
1
Bend middle
5
7
8
6
Slot in cast
head
1. Cut a length of line to 44cm, or use Victa part number TR00200A. Bend line in half at
the centre (equal ends).
Use only 3mm diameter Nylon line
(Fig: 1)
2. Push the bent end of the line under the lug of the trimmer head
3. Push one end of the line into the hole on the same side of the head as the line end. Pull
the line through the hole until loops or slack between the hole centre lug is removed.
4. Repeat step 3 for opposite side.
5. Refer to image for correct complete assembly of the nylon line into the head.
6. To remove used line, bend new line as in (1), slide new line under used line through slot
in cast head.
7. Holding both ends of the new line together, pull the old line out of the cast head.
Repeat process for the other side (8).
Only use genuine VICTA 3mm diameter nylon trimmer line in the Cast Alloy Head.
Unequal lengths of line, or mounting of line "off-centre" will cause vibration &
damage to unit.
Excessive trimmer line length will damage guard and clutch or tangle in head
gearbox. Do not fill head with excessive length line longer than limits of the
guards.
Replace line when worn to approx 50mm from trimmer head body. Remove line by
pushing length back into head or by levering out from centre.
Nylon line will deteriorate over time and may require replacement if line
breakages, line wear & cut performance is not satisfactory
Содержание Victa
Страница 25: ...N o t f o r R e p r o d u c t i o n 22 NOTES ...
Страница 26: ...N o t f o r R e p r o d u c t i o n 23 NOTES ...
Страница 27: ...N o t f o r R e p r o d u c t i o n 24 NOTES ...