Briggs & Stratton Vanguard EFI 380000, Руководство по ремонту

Страница: 94 / 100

5
90
B. Verify that ignition “kill switch” wire is captured in
cable clip on valley shield. See B of Figure 16.
C. Install new cable strap around intake manifold
capturing MAP/MAT sensor conduit and ignition
“kill switch” wire on inboard side. Verify proper
clearance between wires and edges of valley
shield. See C of Figure 16.
D. Verify presence of cable strap securing cylinder 1
ignition coil cable to intake manifold. Install cable
strap if missing. See D of Figure 16.
E. Verify presence of cable strap securing ignition
“kill switch” wire to cylinder 1 high tension lead.
Install cable strap if missing. See E of Figure 16.
F. Install new cable strap to secure fuel injector
connector conduit to fuel injector socket/pin
housing. See F of Figure 16.
5. See Blower Housing, Installation .
NOTE: Fuel pump module connector is connected
during blower housing installation. Be sure to
install new cable strap to secure fuel pump module
connector conduit to socket/pin housing. See Figure
11.
6. See B of Figure 15. On cylinder 1 side of engine,
proceed as follows:
• Connect stator power connector.
• If missing, install
new cable strap to secure
EFI wire harness to outside leg of mechanical
diaphragm fuel pump bracket. See G of Figure
16.
7. See Air Cleaner Assembly, Installation .
16
Not for
Reproduction