Briggs & Stratton IS3200Z Series, Руководство по настройке и регулировке дилера

Страница: 9 / 24

Not for
Reproduction
9
18
7. Have an assistant use the deck lift pedal to raise or lower
the deck linkages as necessary while you install the 1/2
bolt (C) and 1/2 washer (D) through the middle hole (E)
of the mower deck connection points and the spacer and
secure with the hex nylock flange nut (F).
• The hardware used to secure the front of the mower
deck to the deck linkages is routed so that the
threads of the bolt face towards the center of the
mower deck .
• The hardware used to secure the rear of the mower
deck to the deck linkages is routed so that the
threads of the bolt face towards the outside of the
mower deck .
8. Remove the blocking from underneath the mower deck.
Install the Discharge Chute (72" Side
Discharge Export Models)
1. Install the discharge chute (A, Figure 19) onto the mower
deck (B) as shown in Figure 19 using the pivot rod (C).
19
2. Secure the discharge chute to the mower deck using two
(2) 5/16 washers (D) and nylon nuts (E). The mower deck
should never be run without the discharge chute installed
and positioned in the down position.
WARNING
Amputation and Thrown Object Hazard
To avoid injury from rotating blades, stay clear of deck edge
and keep others away. Do not mow without discharge chute
or entire grass catcher in place.
Install the Deck Belt (72" Export Models)
1. Lower the mower deck to it’s lowest cutting position and
remove the mower deck guards and the floor pan of the
machine.
2. Install the long left hand belt (A, Figure 20) through the
PTO clutch pulley belt guide (B) onto the PTO clutch
pulley (C) and the center spindle pulley (D).