Briggs & Stratton 1697363A-00, Руководство оператора

Страница: 7 / 12

7
Note: If the rear frame support hardware INCLUDES the
spacers, proceed to Step 2.
9
1. Remove and discard the existing hardware (a, Figure
10) from the UPPER mounting hole on the left side of
the rear frame support. Repeat for the other side.
10
2. Install the capscrew (D, Figure 11), washer (E), spacer
(F) and nylock nut (G) in the UPPER mounting hole.
Repeat for the other side.
11
3. Install the capscrew (D, Figure 12), washer (E), spacer
(F) and nylock nut (G) in the LOWER mounting hole.
Note: If there are NO holes for installation, refer to Section
"Grass C atche r Templates" for the instructions and
template. Repeat for the other side.
12
Install the Upright Support Assembly
Broadmoor without Suspension
1600/2600, LT Series, CTX 9000 Models
1. Put the upright support assembly (O, Figure 13) on the
spacers (F).
13
Broadmoor with Suspension
1600/2600, LT Series, CTX 9000 Models
1. Put the upright support assembly (O, Figure 14) on the
spacers (F).
14
Conquest
1700/2700, YT and Prestige, 1800/2800, GT Series, CTX
9500 Models
1. Put the upright support assembly (O, Figure 15) on the
spacers (F).
Not for
Reproduction