14
Figure 26
A. Upper Tube
B. Socket
C. Deflector
D. Back Plate
E. Capscrew, 5/16-18 x 1
F. Washer, 5/16
G. Locknut, 5/16-18
H. Lower Tube
I. Middle
Tube
J. Capscrew, #10-32 x 1/2
K. Washer, #10
L. Nut, #10-32
M. Clip
N. Holes
Assembly
A
B
A
B
D
Install Tubes & Deflector
1. Some 50” models covered by this manual require upper
tube (
A
, Figure 26) to be shortened. Shorten tube by
cutting through along line “B” line. See inset, Figure 26.
2. If not already done, insert the upper tube into the socket
(
B
) from the front. This will require some effort.
3. Mount the socket and deflector (
C
) to the back plate
(
D
) using the four 5/16-18 x 1 capscrews (
E
), eight
flat washers (
F
), and four nylock nuts (
G
) as shown in
Figures 5 & 7.
4. Insert the lower tube (
H
, Figure 5) into the middle tube
(
I
). Secure the tubes as shown in Figure 5 using #10-
32 x 1/2 capscrews (
J
), washer (
K
) and #10-32 nut (
l
).
E
F
F
H
G
F
C
I
J
K
L
M
N
5. Insert middle tube and lower tube assembly into upper
tube.
6. Secure the elbow of tube assembly to the turbo using
clip (
M
). Clip may need to be relocated to a different
set of holes (
N
) to ensure secure fit.
Note: Use correct hole locations to maintain proper tube
connections and prevent lower tube from disconnecting
from the turbo.
Not
for
Reproduction
Содержание 1695762
Страница 2: ...2 N o t f o r R e p r o d u c t i o n ...
Страница 19: ...19 N o t f o r R e p r o d u c t i o n ...
