Briggs & Stratton 1695287, Руководство оператора

Страница: 12 / 14

Normal Installation
& Removal
10
Figure 9. Normal Installation & Removal
A. Hitch Support Assembly
B. Bag and Cover Support Assembly
C. Shoulder Bolt
D. Mount Pin
E. Retainer Spring
F. Hinge Pin
G. Retainer Spring
H. Cover Hinge Pivots
I.
Cover
J. Bag
K. Bag Hanger
L. Ridge Cutout
M. Upper Tube
N. Ridge
O. Tube Assembly
P. Rubber Strap
Q. Pin
R. Chute
S. Knob
T. Carriage Bolt
U. Wing Nut
V. Discharge Deflector
W. Carriage Bolt
X. Support Mount
F
C
P
A
T
Q
NORMAL INSTALLATION & REMOVAL
Installation
NOTE: See previous pages for more detailed installation
and operation instructions if necessary.
1. Attach bag and cover support assembly (B, Figure 9)
to hitch support assembly (A) by sliding the support
mount (X) into place until full contact is made with
the shoulder bolts (C).
2. Insert mount pin (D) through support mount (X) and
upright of hitch assembly (A).
3. Secure mount pin (D) with retainer spring (E).
4. Attach cover assembly (I) to bag support assembly
(B) using cover hinges pivots (H). Secure cover
assembly (I) to bag support bracket (B) using hinge
pins (F) and retainer springs (G).
M
N
K
E
B
S
L
5. Raise the cover (I), and attach collector bags (J)
using grass bag hanger (K) to hanger post
(D, Figure 5).
6. Lift discharge deflector (V) up, and Place the holes of
the chute (R) onto carriage bolts (T and W) sliding
the front edge of the chute under the hinge bracket.
7. Secure knob (S) onto carriage bolt (T) as shown.
8. Secure wing nut (U) onto carriage bolt (W) as shown.
9. Slide upper tube (M) into cover (I) aligning ridge (N)
with ridge cutout (L).
10. Slide tube assembly (O) over chute (R)
securing tube assembly (O) to lower chute (R) using
rubber strap (P) on tube assembly (O) to pin (Q) on
chute (R).
R
C
D
I
J
G
F
G
H
U
W
V
X
O