Briggs & Stratton 1694919, Руководство оператора, Страница: 9 / 20

9
Assembly
4. Insert the large loop of spring ( A , Figure 9) through the
hole ( B ) in hitch lift assembly and then the small loop
through eyebolt ( C ).
5. Tighten the hex nuts ( D ) to adjust and apply tension to
the spring.
A
B
C
D
Figure 9
Attaching Snow Blade to Tractor
1. Position snow blade assembly in front of tractor.
NOTE: Make sure that the bell crank ( A , Figure 10) is
rotated to a 45° angle before installing the snow blade
assembly as shown in inset.
2. Align mounting holes on snow blade frame with the
mounting holes in the reach.
3. Insert latch rod ( B ) and secure with hair pin ( C ).
45°
C
A
B
Figure 10
Attaching Hitch Lift Assembly to Snow Blade
1. Attach the hitch lift assembly ( A , Figure 7) to snow
blade assembly ( B ) using 1.25” cap screw ( C ), washer
( D ), spacer ( E ) and nut ( F ).
A
B
D
E
F
F
E
C
Figure 7
2. Secure the hex nut ( A , Figure 8) onto long eyebolt ( B ).
Tighten the eyebolt locknut toward top of threads. See
Figure 8 inset.
3. Insert long eyebolt / locknut through the hole ( C ) at top
of the blade and secure with additional hex nut ( D ).
B
A
C D
Figure 8
Not
for
Reproduction