8
Assembly
Install Reach on to Tractor
1. Remove mower deck.
2. On right side of reach (
A
, Figure 3), install the bell crank
(
B
) through the front holes .
3. Place reach on floor in front of tractor, with the hitch
mounting arms towards the rear of the tractor.
B
A
Figure 3
4. On underside of tractor frame, insert reach support rod
(
A
, Figure 4) as shown and secure with the
cotter pin (
B
) on inside of frame.
IMPORTANT:
The cotter pin must be located along the
inside edge of the tractor frame.
5. Slightly bend longer end of cotter pin. See Figure 4
inset.
A
B
Figure 4
6. Slide the reach (
A
, Figure 5) under tractor and lift to
slide reach mounting arms (
B
) over reach support shaft
(
C
).
B
C
A
Figure 5
7. At front of the machine, locate latch rod (
A,
Figure 6)
and remove hair pin (
B
) and slide out of reach (
C
).
8. Turn the front wheels fully to the left.
9. Lift the reach (
C
) and place the latch rod (
D
) onto the
tractor frame support fingers (
E
).
10. From the left side of the tractor, re-install latch rod (
A
)
through the holes on each side of reach.
11. Secure the latch rod (
A
) with the hair clip (
B
).
NOTE:
Keep the handle portion of the hitch latch pin
towards the front of the tractor.
B
C
B
A
D
E
Figure 6
Not
for
Reproduction
Содержание 1694919
Страница 2: ...2 N o t f o r R e p r o d u c t i o n...
