Not for
Reproduction
9
3. Install fuel cap and let any spilled fuel evaporate
before starting engine.
High Altitude
At altitudes over 1524 m (5,000 ft.), a minimum 85 octane/85
AKI (89 RON) fuel is acceptable. To remain emissions
compliant, high altitude adjustment is required. Operation
without this adjustment will cause decreased performance,
increased fuel consumption, and increased emissions.
See an authorized Briggs & Stratton dealer for high altitude
adjustment information. Operation of the engine at altitudes below
762 m (2,500 ft.) with the high altitude kit is not recommended.
Transporting
When transporting equipment with a vehicle or trailer, turn engine
switch to OFF (0) position. Do not tip engine or equipment at an
angle which causes fuel to spill.
Step 3: Generator Start Up
Disconnect all electrical loads from the generator. Use the
following start instructions:
1. Make sure unit is outdoors on a level surface.
NOTICE
Failure to operate the unit on a level surface may
cause the unit to shut down.
2. Turn the engine switch to the ON (I) position.
3. Push choke lever to CHOKE ( ) position.
NOTICE
To start the engine for the very first time, after
running out of fuel or after a long period of storage, fill fuel
tank as described in
Add Fuel
. It will require more than
several start attempts until the air in the fuel system has
been purged.
5. Grasp recoil handle and pull slowly until slight
resistance is felt. Then pull rapidly to start engine.
6. Slowly move choke lever to RUN ( ) position. If
engine falters, move choke lever to half choke position
until engine runs smoothly, and then to RUN ( )
position.
NOTICE
If engine starts but fails to run, see
Low Oil
Indicator.
QPT (QUIET POWER TECHNOLOGY™)
This feature is designed to greatly improve fuel economy.
When this switch is turned ON (I), the engine speed will
increase as electrical loads are connected, and decreased
as electrical loads are removed.
With the switch off, engine will run at full governed speed.
NOTICE
Always have the switch OFF (0) when starting or
stopping the generator or when using the DC receptacle.
Step 4: Connecting Electrical Loads
Make sure the green output indicator light comes on (it
may take up to three seconds).
Using Extension Cords
When using extension cords or mobile distribution
networks, the total length of cords for a cross section of
1.5mm
2
should not exceed 60 m, for a cross section of
2.5mm
2
this should not exceed 100 m.
Use only grounded extension cords marked for outdoor
use rated for your loads. Follow cord safety instructions.
WARNING!
Damaged or overloaded extension
cords could overheat, arc, and burn resulting in
death or serious injury.
NOTICE
For generator output required see
Generator
Capacity.
Connect electrical loads in off position then turn
on for operation.
230 Volt AC, 15 Amp Receptacles
These receptacles are protected against overload by an
internal overload system.
Use receptacles to operate 230 Volt AC, single–phase,
50 Hz electrical loads requiring up to 1,700 watts (1.7 kW)
at 7.4 Amps of current. Use cord sets that are rated for
230 Volt AC loads at 15 Amps (or greater).
Operation
Engine Switch
Choke Lever
