Briggs & Stratton 030547-01, Руководство оператора

Страница: 9 / 84

Not for
Reproduction
Assembly
Your generator requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115 . If calling for assistance, please
have the model, revision, and serial number from the
identification label available. See Features and Controls
for identification label location.
Unpack Generator
1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner
from top to bottom.
4. Leave generator on carton to install wheel kit.
Shipment Contents
The generator is supplied with:
• Engine oil bottle
• Operator’s manual
• Wheel kit
Install Wheel Kit
NOTICE Wheel kit is not intended for over-the-road
use.
You will need the following tools to install these
components:
• 13 mm wrench
• Socket wrench with 13 mm socket
Install the wheel kit as follows:
1. Tip generator so that engine side is down.
2. Slide axle stud ( A ) through wheel ( B ).
NOTICE Be sure to install wheel with raised hub
inboard.
3. Slide a spacer ( C ) over axle stud on back side of
wheel.
4. Slide axle stud through mounting bracket.
5. Insert retaining pin ( D ) through hole on axle stud.
6. Repeat steps 2 through 5 to secure second wheel.
7. Line up holes in support leg ( E ) with holes in
generator frame.
8. Attach support leg using two 16 mm capscrews
( F ) and two M8 hex nuts ( G ). Tighten with a
13 mm socket wrench and 13 mm wrench.
9. Return generator to normal operating position
(resting on wheels).
10. Slide handle bracket over generator frame and
attach handle ( H ) using two 50 mm capscrews ( J )
and two M8 hex nuts ( K ). Tighten with a 13 mm
socket wrench and 13 mm wrench.
9
D
B
C
A
F
G
E
J
K
H