— 25 —
2384.01 -2020
Main conditions of long service life is right and careful servicing. Avoid excessive increasing of pressure in the board, especially from heating
by the sun rays.
After exploitation take off sand and dirt from boat surface, and carefully dry it.
Avoid the water getting into the chambers. If a fuel or an oil gets to the boat surface it is necessary to wash the soiling place by soap water as soon
as possible and dry.
Pay attention to the condition of bottom surfaces. If it's cover is destroyed it is necessary to dry this element and restore the defend cover.
After season prepare the boat to winter keeping. Clean boat surface from sand and dirt and make the necessary repairs, if damages take place. If
it is possible, keep the boat in the open and slightly pumped state in air temperature 0-25°C. The boat must be protected from the sun rays.
Insignificant boat repairing (eliminating the board punctures or cuts) you may carry out by yourself. In this case use the coated fabric and glue set
for repair from the complete set.
Independent performance of any complex repair associated with considerable damages to the board, partitions and seams is not recommended. In such
cases, apply to your dealer.
MAINTENANCE.
Storage of the boat with temperature variations from -30°C to +45°C may be allowed for not longer
than 1 month.
In case the boat has being stored or transported at a temperature bellow 0°C, it must be held at a
temperature above +15°C for at least 1 hour before be unpacked and unfolded.
For small repair boat tube use the coated fabric and glue set from the complete set.
PREPARATION FOR EXPLOITATION.
In order to set the boat in the operation condition perform as follows:
Unfold the inflatable balloon.
Apply the foot pump to fill the afterbody of the compartments with air to the pressure being slightly below its rated value (the balloon will be
completely straightened). Then fill the forebody compartment with air up to the rated pressure.
The rated pressure value is 0.15 bar (2.2 pci).
On completion of filling close the valves with bonnets B (rotate them clockwise), (look before).
Assemble the oars by entering the removable parts with blades into the locks until the click. Secure the oars in the holders.
When mounting the outboard engine make sure that it is reliably fixed to the transom. In addition, take every precaution to avoid any contacts
of the fuel with the boat surfaces.
In order to discharge air from the compartments, open the valves (by counterclockwise rotation) and switch the valves over into
condition "OPEN" (look before).
