X-treme
12
2.6.Connecting and testing the system.
After programming the antennas pads (see section 1.6) and installing the antenna system within
the loft (see section 1.3), the power supply can then be connected to the system.
The Speedy clock can be connected either prior to or after the connection of the power supply.
Each of the lights on the antenna connection boxes will illuminate red.
If this fails to occur than there is a problem with the power supply or the cable connections.
X-treme clock
(Female)
Connection cable
(male)
Long kabel
(female)
Antenna Connection
(male)
Attach the antenna cable (long cable) to the clock and then the cable
to the antenna. The mail side (pins) directed to the clock
Mount additional antennas after they are programmed
If you connect more than one antenna, it is recommended to place
the power centrally between the antennas. A heavier power supply
is necessary when you using multiple antennas.
After programming the antennas you can connect all the antennas with
connection cables.
If you use more than 5 antennas attached the end-plug.
With an antenna test (Page 8) You can easily determine if your system
operates reliably
You can now connect the X-treme to the antennas and the clocking
starts automatic if there are pigeons coupled in the clock.
If a race is basked, the X-treme starts in clocking mode. (to stop the
clocking mode disconnect the X-treme from the antennas
If no race is basked the X-treme start in training mode (to stop training
mode press <C> ).
M
See drawing
Page 5
Содержание X-treme
Страница 2: ......
