breviglieri MEKFARMER 150, Руководство по эксплуатации и техническому обслуживанию

Страница: 30 / 120

- 30 -
mekfarmer 1 5 0
macchine agricole
Further runs will be required if the soil is too hard
▪
The blades slide over the ground instead of digging into the soil: advance more slowly
▪
Soil crumbled too finely
Lower the speed of the blade rotors
▪
Increase the tractor ground speed
▪
Soil insufficiently worked
Increase the speed of the blade rotors
▪
Reduce the ground speed
▪
Do not work if the soil is too wet
▪
If the levelling bar is installed, try lifting or lowering it
▪
Clogged rotors
Soil to wet to work
▪
Raise the levelling bar
▪
Reduce the ground speed
▪
Do not work where the grass is too tall
▪
The machine jolts over the ground or vibrates
Foreign bodies locked between the blades
▪
Blades incorrectly mounted in the wrong positions
▪
Worn or broken blades
▪
Blades bent during work after hitting stones or having worked excessively hard soil
▪
The machine vibrates too much
Reduce the ground speed of the tractor
▪
Adjust the machine in the correct way, as described in the instructions
▪
Clean the rotors. They could be clogged
▪
Check whether any blades are broken. Replace them if this is the case
▪
The rotors turn in an uneven way
Make sure that the driveline clutch is regulated correctly
▪
Excessively elastic clutch springs. Replace the springs
▪
The gearboxes overheat
Check the oil level and top up if necessary
▪
The driveline clutch overheats
Check the clutch plates for wear. Have them replaced by an authorized workshop if necessary
▪
Excessively elastic clutch springs. Replace the springs
▪
4.8 TINES
The blades fitted on the implement are suitable for soil of a normal consistency. Check them daily to make sure that they are in a
good condition and not worn. If the blades should accidentally bend (or break) during work, they must be immediately replaced.
Make sure that the new blades are mounted in exactly the same positions as the old ones. If several blades must be replaced, it
is advisable to demount and remount them one at a time in order to avoid positioning errors. The sharp side of the blades must
point towards the direction in which the blade rotor turns.
DANGER
Blade replacement is a dangerous operation.
Proceed in the following way to change the blades:
Park the tractor on a flat surface with the machine hitched, then raise the machine with the power lift
▪
Insert two strong bearing stands at the sides of the machine
▪
Lower the machine on to the stands, turn off the tractor engine and apply the parking brake
▪
CAUTION
If blades must be changed, make sure that the new ones are mounted in the same positions as the old ones.