Step 3
Sync
iPad devices using the PowerSync Tray
1.
Once you have created the content & organized your
playlists within iTunes, and set-up each individual iPad
Device per the instructions on pages 3 please start
with the following configuration:
• Each iPad Device is connected in the tray
• Mac is “ON” with no applications running
• PowerSync Tray is plugged into wall and
Switch is in “OFF” position.
2.
Connect the USB Cable from the back of the tray to your Mac
Note: USB 2.0 port on your Mac is recommended
3.
Turn main Power Switch on back of tray to “ON” position.
4.
iTunes will automatically launch – then wait until your
Mac shows each iPad device
Note: This may take a few moments to complete.
Each iPad device will automatically appear in iTunes & begin syncing
.
The spinning wheel to the right of each iPad device indicates that syncing is in progress.
Sync is complete when spinning wheel disappears.
5.
Once the Sync Process is complete, eject each iPad device or simply close iTunes to eject all at once.
6.
Unplug the USB Cable from your Mac, and the iPad devices will then charge.
NOTE: iPad devices will not charge and sync at the same time!
Step 4
Store & Charge
iPad Devices in the PowerSync Tray
Plug in Power Cord on the left back of the tray
1
2
Page 2
CAUTION:
Ambient temperature not to
exceed 35°C ( 95°F ).
PowerSync Tray should only be
used indoors
User can only connect 10 iPad
devices at one time
Input Power Cord must meet
these specifications: A certified
power supply cord must be used
with this equipment. The relevant
national installation and/or
equipment regulations shall be
considered. A certified power
supply cord not lighter than
ordinary polyvinyl chloride
flexible cord according to IEC
60227 (designation H03 VV-F)
shall be used. Alternatively, a
flexible cord of synthetic rubber
according to IEC 60245
(designation H05 RR-F) shall be
used. The power cord set shall
have a power supply cord with
conductors providing a cross-
sectional area of 3G, 1.00mm
2
minimum, and shall have an IEC
plug.
Turn power switch
on back of tray to
“On”.
NOTE: PowerSync
Tray will charge up
to 10 iPad devices
NOTE: For best
results with new
iPad devices, let
them charge for
about 4 hours or
until the iPad
device displays a
charged battery.
Insert each iPad device into a slot, attaching the 30-pin dock connector cable.
NOTE: The gray Bretford logo on the 30-pin dock connector should face the same side as iPad device screen
.
3
IEC Plug for Power Cord
On/Off Switch
USB Plug B-Type, cable
to the Host MacBook
BACK VIEW
4
Individual LED
Lights (one for
each slot) glow
“amber” while
charging, then
“green” when
fully charged.
