Bresser XXL Weather Center JC, Быстрый старт

Страница: 17 / 20

17 / 20
8. Slide 4 screws through the bore holes of the assemby base and through the bore holes of the tube
bracket on the other site.
9. Put on the 4 nuts and tighten the screw connection by hand.
11 Signal transmission
The base station will automatically connect to the outdoor sensor. Press the SENSOR button to start a
manual search for the sensor. When the connection is successful, the sensor signal strength indicator
will be shown on the display.
Connection status display
Connection status Screen display
Good signal Reception symbol
Searching for a sensor Reception symbol flashes
No signal for 48 hours 'Er' (Error) is shown
Sensor low battery status, good signal Battery symbol is shown
12 Automatic time setting
After the power supply was established, the clock will automatically search for the radio signal. The
clock will automatically search for the radio signal.
If the radio signal is received correctly, the date and time will be set automatically and the radio control
signal icon turns on.
If the clock fails to receive the time signal, go ahead with the following steps:
1. Press RCC button on the base station until radio signal symbol flashes.
2. If the device is still not receiving the signal, the time must be set manually.
Read the detailed manual for more information about manual time and alarm setting (see download in-
formation on page 2).
13 Receiving measurements automatically
Once batteries are installed, the base station will display the measurement readings. Readings from
the remote sensor will be displayed within 3 minutes after powering it on.
Read the detailed manual for more information about readings (see download information on page 2).
14 EC Declaration of Conformity
Hereby, Bresser GmbH declares that the equipment type with item number 7002590 : is in compli-
ance with Directive: 2014/30/EU. The full text of the EU declaration of conformity is available at the
following internet address: www.bresser.de/download/7002590/CE/7002590_CE.pdf
15 Cleaning and maintenance
• Before cleaning the device, disconnect it from the power supply (remove plug or remove batteries)!
• Only clean the device externally using a dry cloth. Do not use cleaning solution to prevent damage
to the electronic parts.
Cleaning the rain collector (sinkhole)