Bresser ClimaTemp WS, Инструкция по эксплуатации

Страница: 9 / 12

9
minutes, then it alarms again. This snooze function can be enabled for maximum
7 times.

Except “SNOOZE” button, press any buttons to stop the snooze alarm. Otherwise,
the alarm signal sounds for about 2 minutes, and then stops automatically.
8. Light

Press “DIMMER” button (B4) to adjust the LED brightness.
9. Low battery indication:
The low battery icon “ ”will appear and indicating that thermo sensor is in
low battery status. The batteries should be replaced.
10. Precautions

Use a pin to press the reset button if the unit does not work properly.

Avoid placing the clock near interference sources/metal frames such as computer or TV sets.

The clock loses its time information when the battery is removed.

Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas

The outdoor sensor must not be set up and installed under water. Set it up in away direct
sunlight and Rain

Never clean the device using abrasive or corrosive materials or products. Abrasive cleaning
agents may scratch plastic parts and corrode electronic circuits

If there is any inconsistency of weather forecast between Local Weather Station and this unit,
the Local Weather Station's forecast should prevail. The manufacturer will not take
responsible for incorrect forecasting from this unit
11.
EC Declaration of Conformity
Hereby, Bresser GmbH declares that the equipment type with part number: 7007320
is in compliance with Directive: 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
www.bresser.de/download/7007320/CE/7007320_CE.pdf