Bresser ClimaTemp WS, Инструкция по эксплуатации

Страница: 7 / 12

7

Hold “OUT-TEMP ALERT” button (B8) for 3 seconds to enter outdoor
temperature alert setting. Icon “ ” or “ ” beside temperature’s digits flash.
Press “
▼
” or “
▲
“button (B1 or B3 button) to adjust the setting value, press
“OUT-TEMP ALERT” button to confirm the setting. Setting Sequence as follow:
Upper limit of temperature, Lower limit of Temperature.

When it’s alert, the corresponding icon “ ” or “ ” and temperature digit
would flash on the LCD. Press any buttons to stop the alert sound
,
otherwise, it
will sound for 2 minutes, and stop automatically.
(6) Comfort Indicator Bar: for the display of pleasant/unpleasant climate.
7. Time and Alarm Setting
7.1 Radio Controlled Clock:

After batteries inserted and main unit finishes receiving the transmission from
outdoor sensor, the clock automatically starts to scan the DCF time signal. Radio
Control Icon“ ” flashes on the LCD.
flashes
，
Indicating now is receiving
DCF signal
turns on,
Indicating signal received
successfully
disappear,
Indicating signal reception
failed

The clock automatically scans the time signal at 3.00 a.m. every day to maintain
accurate timing. If reception fail, scanning stops (“ ” on LCD disappear)

The clock can be set to scan the time signal manually by holding “ ▼ ” and
“
▲
“button for 3 seconds. Each reception takes about 5 minutes. If receptions
fail, scanning stops.

Stop scanning by holding “ ▼ ” and “ ▲ “button for 3 seconds.

“
DST
” shown on the LCD if it is in daylight saving time mode.
7.2 Manual Time Setting:

Hold “MODE” button (B2) for 3 seconds to enter Clock/Calendar setting mode.

Press “ ▲ ” or “ ▼ ” button to adjust the setting and press “MODE” button to confirm
each setting.
(By keeping the “ ▲ ” or “ ▼ ” button pressed, could accelerate the process and reach