21
GB
Power Save
Off
No auto power off (Default Setting)
5min
Auto power off in 5 mins without actions
10min
Auto power off in 10 mins without actions
15min
Auto power off in 15 mins without actions
30min
Auto power off in 30 mins without actions
Date
YY/ MM/ DD
Press TRIGGER knob to enter menu.
Press ZOOM or IR knob to go left and right or up and down
Press TRIGGER knob to save settings and exit
Time
hr/ min/ sec
Press TRIGGER knob to enter menu.
Press ZOOM or IR knob to go left and right or up and down
Press TRIGGER knob to save settings and exit
Flicker
60Hz
Default setting for U.S. and Japan
50Hz
Default setting for EU
LCD Backlight
Default setting is 5.
Indicating backlight levels (0-9). The higher the setting, the brighter the display.
Date/ Time Tag
Off
Default setting is off
On
Date/time Tag is visible on photos
Version
Info on firmware version (for reference only)
Troubleshooting
Device Power Off:
• If the device fails to activate, check for defective, missing or improperly-installed batter-
ies. Replace or install batteries correctly. Please make sure to use only Alkaline batteries.
Poor Image:
• If you wear glasses, please keep them on while using the device.
• For night observation, make sure that IR (infrared) is switched on. The darker the envi-
ronment, the higher the infrared illumination.
• Adjust the focus by slowly turning the Focus wheel at the front bottom of the device.
Make sure it is focused.
• During daylight hours, make sure the IR is off. For use during nighttime hours, make
sure the IR is on.
Message “Please insert SD card” is shown but card is inserted
• Turn off the device and insert the card aain in the direction as shown in the graph.
Note: The microSD card must to be inserted when the device is powered off.
• Check the microSD card compatibility.
• Try to insert the card more smoothly or insert a different microSD card.
