5
control to position at
“‥”
Attention: The temperature on the soleplate is very hot and may burn the inner side of the
fabric brush after some time and use.
For best ironing results:
•
Some garments should be ironed inside out.
•
When ironing, touch the fabric lightly with the iron and move it in different directions to
remove wrinkles. It is important for the iron to touch the fabric of the garment.
•
The iron will not remove stains from a garment
•
Steam brush and iron combination can be used with almost any kind of fabric, including
silk, cotton, polyester and wool. Please read the garment’s care label to check that it can be
steam ironed. Certain materials such as leather, suede and velvet cannot be steam ironed.
•
To ensure the garment can be steam ironed, test the iron on a small part of the interior of
the garment. If no damage occurs, the entire garment can be ironed.
Cleaning and maintenance
•
When you have finished using the Steam brush and iron combination, make sure
that it is completely unplugged from the mains before starting to clean it.
•
Allow the water in the appliance to cool for 15 minutes. Then carefully remove the
water- reservoir cap. Turn the appliance upside down to empty out all the water
•
Clean the appliance and accessories only when they have completely cooled.
•
Store the appliance in a dry, safe place
Warning: Never put detergent, chemicals, salt, perfume, dye or any other liquid
except water into the water reservoir. Many of these substances are highly flammable
and may cause bodily harm, while certain additives can corrode and clog the
appliance’s components. Never should you add essences to perfume water.
Removing mineral deposits:
A common problem with steam irons is the accumulation of mineral deposits in the
tubes, normally when tap water is used to fill the iron. To reduce or remove these
mineral deposits, use filtered, mineral or distilled water. The following steps, if taken
at least once a month, can be reduce the level of mineral or distilled water cannot be
used:
1.
Ensure the appliance is unplugged from the mains and cool.
2.
Make a solution that is 50% vinegar and 50% water. 60g is enough. Pour in the
solution into water tank.
3.
Allow it steam for 40 minutes, adding more solution when the water reservoir
becomes empty
4.
Pour the solution remaining in the water reservoir into the sink or other container
5.
Fill the water reservoir with water and then empty it again. Repeat until the
vinegar smell has gone
