14
14
Operating Instructions
JARO
INSTALLATION AND CONNECTION TO POWER SUPPLY 10 – 50 W
see figures p. 4, 7 and 8
1. Before installation, always switch off the voltage supply
1
.
2. Installation position: the floodlight should ideally be mounted using the wall bracket. The
floodlight must be installed at a height of less than 3 m
8
.
Recommended installation height for models with motion detector 2.5 m. The floodlight can
be angled up and down.
3. Remove the mounting bracket from the floodlight
2
.
4. Mark the position of the drill holes for fastening the mounting bracket and drill
corresponding holes into the wall
2
. Attach the bracket to the wall using suitable screws.
5. Open the plug connection
3
.
6. Feed the connection cable through the plug sleeve, which has a seal
4
.
7. Attach the floodlight to the mounting bracket.
8. Connect the strands of the connection cable to the luster terminal in the input connector in
accordance with
5
(N = blue cable, earth symbol = green/yellow cable, L = brown cable).
9. Slide the cases over the input connector as shown in
6
and tighten it. Take care to ensure
that both cases are sufficiently tightened – this ensures a sufficient seal.
10. Re-attach the mounting bracket to the floodlight.
11. Adjust the desired position of the floodlight and fasten the U bolts.
12. Switch the supply voltage back on
7
.
INSTALLATION AND CONNECTION TO POWER SUPPLY 80 – 150 W
see figures p. 5 and 6
Mounting position: The spotlight should be ideally fixed with the wall bracket. It must be
installed at a height less than 3 m
AT
.
The light can be tilted by 90° downwards and by 45° upwards
AT
.
1. Always turn off the power supply before installation
1
.
2. Unscrew the junction box
2
on the back and loosen the pressure plate
3
.
3. Insert the connection cable
4
through the inlet pipe of the junction box and connect the
braids of the connection cable according to marking N and L
4
.
4. Fasten the pressure plate and screw the junction box on
5
.
5. Remove the retaining bracket from the spotlight
6
.
6. Mark the position of boreholes
7
for securing the retaining bracket and drill the respective
holes on the wall. Attach the bracket to the wall with suitable screws
7
.
7. Secure the spotlight to the retaining bracket
8
.
8. Adjust the desired position of the spotlight and tighten the U-bolts
8
.
9. Turn the power supply back on
9
.
20P114 LED Strahler Jaro PIR 0533228 210327.indd 14
20P114 LED Strahler Jaro PIR 0533228 210327.indd 14
27.03.2021 16:10:47
27.03.2021 16:10:47
