12
EN
Wireless Brightness Sensor 868.3 MHz
Wireless Brightness Sensor 868.3 MHz
Function
The wireless brightness sensor is part of the Brennenstuhl Home
Automation Systems BrematicPRO, controlled via app or the BrematicPRO
PC software.
The wireless brightness sensor detects the ambient brightness (in Lux)
at a measuring interval of approx. 5 minutes and reports these values
to the BrematicPRO Gateway. The brightness values will be displayed
in the app or the PC software BrematicPRO.
Inserting / replacing the battery
Remove the installation plate by pulling it off.
Loosen the four screws from the battery cover and open the
battery compartment.
If applicable, remove the drained batteries.
Insert the batteries into the battery compartment with correct
polarity. Please note the marking inside the battery compartment.
Close the battery cover and attach it with the four screws after
you have paired the product to the BrematicPRO Gateway.
The wireless brightness sensor is now ready for use.
Download app / PC software BrematicPRO
The Brennenstuhl Home Automation Systems BrematicPRO is controlled
via the BrematicPRO app / PC software. The app can be downloaded for
free from the App Store and Google Play. The PC software is available
for download at www.brematic.com/gb/service.
Please follow the on-screen instructions for download and installation.
For more information about the app and how to use it, please visit
www.brematic.com/gb/service.
Installation
Note:
Carry out the wireless brightness sensor pairing process with
the BrematicPRO Gateway before beginning installation.
Note:
Check before installation whether the product is located within
the range of the Gateway.
Installation using screws
CAUTION! DANGER OF ELECTRIC SHOCK!
Make sure that
you do not damage electrical cables in the wall during installation.
An eaves, for example, is particularly suitable for outdoor installation.
Remove the installation plate from the device.
Draw the four drill holes on the wall using a pen, with the help
of the installation plate.
Drill the marked holes using a suitable drill and insert the dowels.
Screw the installation plate to the wall using the screws provided.
Note:
When installing on a wood surface, use a 1.5-2 mm drill.
You will not require any dowels.
Place the device on the installation plate fastening pin and press
it down firmly.
Pairing the wireless brightness sensor with
the BrematicPRO Gateway
When linked with the Home Automation Systems BrematicPRO via
the BrematicPRO Gateway, you can use the app/BrematicPRO PC
software to use additional software-based functions, e.g. functions
such as controlling actions (tasks), switching devices on / off.
The app or BrematicPRO PC software is installed and open.
The BrematicPRO Gateway is ready for use.
Keep the device at least 50 cm from the Gateway.
Open the “Settings“ menu.
