9
9. Thread the line
1. Thread the line through the Tensioner Cover.
2. Pull the line down through the top of the Line Tensioner. (Step 1)
3. Loop the line back up through the right hand hole leaving a loop below. (Step 2)
4. Loop the line up over, threading the line down the left hand hole pulling tight, feed the end of the line through the loop
underneath of the Tensioner. (Step 3)
5. Pull tight and trim the excess length. Clip the Tensioner Cover into position. (Step 4)
6. Feed the line through each line sleeve backwards and forwards between the Arms keeping the lines tight. (Step 5)
7. When you reach the end Tensioner, repeat steps 1 to 4 to secure the line.
Note: Do Not Over Tension The Lines.
Step 1
Step 2
Step 3
Step 4
Step 5
Line Direction
