screw
rail with tab
rail with
tab
body
door
tray
velcro tabs
open slot
Dura-Whelp Box Assembly Instructions
BreederBase
PO Box 8, Clifton, ID 83228
208-747-3605 Fax 208-747-3604
www.BreederBase.com
Important
Save reusable shipping carton
for storing your Dura-Whelp
Important Notes:
To dismantle the Dura-Whelp, clean then reverse steps 1, 2 & 3,and repack.
1
. Square up the body section of your Dura-Whelp and
place on top of tray. On inside of tray flaps, remove
protective film from velcro tabs. Fold up tray flaps and
affix to the body section of your Dura-Whelp.
4
. Your completed Dura-Whelp.
3
. Insert [2] rails with tabs on ends. Hold down firmly and screw
down through hole as shown. DO NOT OVER-TIGHTEN. Use
provided screws. [See detail for information]. Remove
protective film from velcro tabs on rails and affix to the Dura-
Whelp body.
2
. Insert [2] rails (without tabs) into open slots on
the front and rear body section of the Dura-Whelp.
The door on the front of your Dura-Whelp slides
up & down.
