28
Chapter 5: Attaching the Bed Face Panel to the Bed Cabinet.
1.
Referring to Fig. 5C, stand the Bed Face Panel in vertical
position between the mechanism arms, lifting until the bolt in
Hole #3
drops in the slotted portion of each mechanism arm.
2.
Gently tilt the Bed Face Panel outward toward you until the
Allen bolts in
Hole #1
hits (and is completely seated in) the
bottom corner notch of each mechanism. This is used as a
positioning guide to align
Hole #2
with the mechanism.
3.
Insert the remaining 5/16 Hex head bolts from hardware card #2, through the
mechanism arm into
Hole #2
on each side and thread on the 5/16” Nylock nuts
from hardware card #2. Securely tighten these nuts and the nuts on
Hole #3
with
the 1/2” Socket and wrench.
STEP 4
Verify the bolts in Holes #2 and #3 have been inserted and
secured on each side (4 bolts total).
Tilt the Bed Face Panel outward (to approximately 45 degrees)
to release the mechanism arm locks. You may hear a click as
they disengage.
STEP 5
FIG. 5C - LOOKING THROUGH LEFT SIDE
FIG. 5D - LOOKING THROUGH LEFT SIDE
Hold the Bed Face Panel securely and DO NOT let it slam shut.
Balance is not achieved until the mattress is loaded in the bed. DO NOT
attempt to adjust the bed at this time, adjustments will be done later.
For video instructions of this specific chapter, visit:
breda.us/face
NEVER REMOVE THE SCREWS IN “BED CABINET TOP NAILER”
FROM THE WALL WITHOUT FIRST REMOVING THE BED FACE PANEL.
THE BED CABINET WILL COLLAPSE OTHERWISE.
DO NOT ATTEMPT TO PRY OFF THE MECHANISM ARM FROM THE FRAME
WHEN THE MECHANISM ARM IS UNDER TENSION. IF YOU NEED TO
REMOVE THE BED FACE PANEL, RE-ENGAGE THE ARM LOCKS AND
LIFT OFF THE BED FACE PANEL. SEE CHAPTER 8, STEPS 1 & 2.
If you have trouble aligning the bolt in hole #2, contact us for a solution.
