4
Breckwell
ASSEMBLY INSTRUCTIONS
This appliance is offered in three different con
fi
gurations of which you get to choose. You have the option to install your new heater
as a freestanding heater on a pedestal, on legs or as a
fi
replace insert.
You must purchase the desired kit separately from your
appliance dealer.
Read and follow the directions in this manual and inside the chosen kit to ensure proper assembly, installation
and operation of your new wood heater.
Caution! The appliance is very heavy.
The assistance from a second person is strongly suggested. Please use proper lifting technic when positioning the appliance for
assembly and installation. Several methods may be used to attach the legs and pedestal to the appliance. The safest method is to roll
the appliance on its back, then attach the chosen assembly. When using this method, you should
fi
rst remove the
fi
rebrick from the
unit so as to reduce weight and possible breakage. It will be required to raise the bottom of the unit up to attach two of the legs or
the pedestal. It is recommended that you use cardboard or other means of padding to protect the
fi
nish on your new stove.
FREESTANDING LEG ASSEMBLY
Unpack the kit and ensure all components are present:
Four(4) Cast Iron Legs (40566), Eight(8) 1/4-20 UNC Bolts
(83339) and Eight(8) Flat Washers (83045A).
1)
Position the unit for assembly.
2)
Using the Eight(8) 1/4-20 bolts and washers provided,
attach the legs.
3)
Rotate the appliance onto the legs, being careful not to
damage the legs while doing so.
4)
Make sure that the baf
fl
e board, above the air tubes, is
in place and undamaged. DO NOT remove the baf
fl
e
board.
FREESTANDING PEDESTAL ASSEMBLY
Unpack the Pedestal Assembly and ensure all components are
present: One(1) Pedestal Assembly, Six(6) 1/4-20x1/2 Hex Head
Bolts, and Four(4) #10x1/2 Hex Head Self-tapping Screws. The
pedestal should come assembled to the base, ready to install on
your appliance. You can either roll the appliance onto its back as
above or locate the pedestal assembly in the approximate
fi
nal
location, then set the appliance atop the pedestal.
Caution! The appliance is very heavy.
1)
Position the appliance for assembly.
2)
Attach the pedestal to the bottom of the unit using four(4)
bolts provided.
3)
Attach the pedestal back to the pedestal using four(4)
sheetmetal screws provided.
4)
Make sure that the baf
fl
e board, above the air tubes, is in
place and undamaged. DO NOT remove the baf
fl
e board.
If an outside combustion air source is needed see the
“Combustion Air Assembly Instructions”
section in this
manual.
FREE STANDING ASSEMBLY
