P a g e
18 | 24
The V-MUX software takes over the devices and displays them in the "Virtual MUX" area:
In addition, the units are now shown in the channel view, but not yet as connected:
Click on "Connect" at the bottom right. The V-MUX software establishes the connection to the
measuring devices and to the output interface and is then ready to perform measurements and
transmit the measured values.
REMOVE CHANNEL:
Proceed as follows to remove a channel from the selected unit:
•
Right-click on the channel to be removed.
•
Click on "Delete channel"
Channels can only be removed in the disconnected state of the V-
MUX software. The large button at the bottom right is green in the
connected state and indicates "Disconnect". A click on the button
disconnects the connection.
