E:
P:
905.873.8509 Toll Free: 1.877.260.4309
http://brc.group/
Page
3
of
10
c. Direction for Use
1. Correctly connect the Control Box, Patch Cords Lifting Columns, Handset, Power
Cord, in the sequence shown above. Note always power control box last!
2. Plug the power cord into 110~220VAC outlet The LCD display will show “PON” for
seconds indicating a positive power connection system resetting.
After resetting the LCD display will display
21.6(INCH)
, reset finished.
Reset: (Initialization)
Press and hold the down button, until handset display "RES" and then release button,
The desk will begin to lower, until to the lowest height then slightly rise. Reset finished.
3. After reset, table can be operated normally. press and hold “Up” button to move the
table in an upward direction. Display will show height of table. Release “Up” button
at desired height.
4. To lower table press and hold the “down” button. Display will show height of table.
Release “Down” button at desired height.
Setting Memory Positions
Press and hold UP/DOWN button to desired height, press button M first, then press
button 1, this height will be remembered by button 1.
Press and hold UP/DOWN button to another desired height, press button M, then
press button 2, this height will be remembered by button 2.
Repeat steps above for position 3 and 4 .
After setting memory positions, press 1/2/3/4 button, desk will move to the stored
position. At any time press “UP” and “DOWN” button. The motion will be stopped.
