BRAYER BR4915, Инструкция по эксплуатации

Страница: 7 / 36

7 EN
• To switch the night mode on, press and hold the
button (7) « » for 2 seconds, the button (7) « »
lighting will light up blue.
• If the water tank (2) is empty, the button (7) « »
lighting will light up red.
• Remove the power plug from the mains socket.
• Fill the tank (2) with water, install it to its place and
switch the unit on.
• After the operation switch the air humidifier off and
unplug the power cord plug from the mains socket.
CLEANING AND MAINTENANCE
• Hard water causes the appearance of mineral scale
inside the process chamber (5), on the sprayer and
in the water tank (2); mineral scale leads to improper
operation of the humidifier.
• It is recommended to clean the process chamber (5)
and the sprayer weekly, and to change water in the
water tank (2).
• If you are not going to use the Ultrasonic humidifier
for a long time:
- pour the water out of the water tank (2) and the
process chamber (5)
- wash and clean the process chamber (5) and the
sprayer
WARNING!
Always switch the Ultrasonic humidifier off and unplug
it before maintenance works or cleaning.
- wash the water tank (2)
- dry the unit thoroughly and take it away for
storage.
WEEKLY CARE
• Ceramic water filter (4) is permanent and it doesn’t
have to be replaced for a long period of time. It is
recommended to remove the filter (4) every 7 days
and wash it with warm tap water. After that install the
filter (4) back to its place.
• Note: — the ceramic filter (4) cannot clean the water
from mineral deposits fully and it serves as additional
means of cleaning of the water.
• Once a week wash the water tank (2), the process
chamber (5) and the sprayer with warm water and
neutral detergent and rinse thoroughly with water.
• Add some detergent drops on the sprayer and wait
for several minutes. Remove the deposits from the
sprayer surface with a brush.
• Notes: — you can use scale removal substances for
electric kettles as a cleaning agent for the process
chamber (5) and the sprayer strictly following the
instruction.
• Clean the unit body (6) with a slightly damp cloth and
then wipe the body (6) dry.
• Do not immerse the unit body (6), the power cord and
the power plug into water or other liquids. Provide
that no liquid gets inside the unit body (6).
• Do not use solvents or abrasives to clean the surface
of the body (6) and the water tank (2).