BRAYER BR4883, Инструкция по эксплуатации

Страница: 6 / 36

6 EN
by the manufacturer, a maintenance service or
similar qualified personnel to avoid danger.
• If a foreign smell appears, immediately stop using the
unit, try to visually determine the cause of the foreign
smell, a possible reason is a foreign object present
on the heating element, if possible, remove the
foreign object from the heating element, otherwise
contact the service center.
• Do not repair the unit by yourself. Do not
disassemble the unit by yourself, if any malfunction
is detected, and after the unit was dropped, unplug it
and apply to the service center.
• To avoid damages, transport the unit in the original
package.
• Keep the unit in a dry cool place out of reach of
children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
OR LABORATORY PURPOSES.
BEFORE THE FIRST USE
After the unit’s transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using it.
• Unpack the unit and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specified specifications of power
supply voltage of the unit correspond to the
specifications of your mains. When using the unit in
the mains with 60 Hz frequency, the unit does not
need any additional settings.
• Wipe the convection fan heater body with a slightly
damp cloth and then wipe it dry.
ASSEMBLING AND INSTALLATION
Stand mode
• Turn over the unit body. Match the openings on
the feet (6) with the corresponding openings in the
bottom part of the unit body.
• Fix the feet (6) with the screws supplied with the unit.
(pic.1)
Note: you can install the convection fan heater directly
on the feet (4) (pic. 1) or you can insert the wheels (5)
into the feet (4).
• Turn over the unit and place it on an even steady
surface.
• Fix the carrying handle (2) with 2 screws M4x16mm
(pic.2).