BRAYER BR2330, Инструкция по эксплуатации, Страница: 6 / 36

6 EN
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
OR LABORATORY PURPOSES.
BEFORE THE FIRST USE
After unit transportation or storage at negative
temperature, unpack it and wait for 3 hours before
using.
• Unpack the unit and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specified specifications of power
supply voltage of the unit correspond to the
specifications of your mains. When the unit is used in
the mains with 60 Hz frequency, it does not need any
additional settings.
• Clean the unit body surface and the frying plates (5)
with a soft, slightly damp cloth, and then wipe it dry.
• Install and use the unit on a flat, dry, steady and
heat-resistant surface with free access to the mains
socket.
• Use the unit in a well-ventilated room, for normal
air circulation the free space around the nut maker
should be at least 10-15 cm on each side.
• Take the handle (1), lift the lock (2) and open the nut
maker.
• Simultaneously press the locks (4) and remove the
lower frying plate, then remove the upper flying plate
in the similar manner by pressing the locks (5).
• Wash all the frying plates (6) with warm water and
neutral detergent, rinse them and wipe dry.
• Install the required frying plates (6), to do this insert
the bottom part of the plate first and then press on
the upper part of the plate until the lock (4 and 5)
clicking. Make sure that the frying plates (6) are fixed
properly.
• Before using the unit for the first time and before
baking nut waffles, it is recommended to smear some
vegetable oil over the frying plates (6).
• Close the nut maker and insert the power cord plug
into the mains socket, the indicator (3) will light up
orange.
• When the indicator (3) lights up green, unplug the nut
maker and wait until it cools down completely.
• Take the handle (1), lift the lock (2) and open the
nut maker. Remove the remaining oil from the frying
plates (6) with a paper towel or a clean cloth.
Notes:
- when you switch the unit on for the first time, some
smoke or foreign odor may appear. It is normal
and not covered by warranty.