BRAVILOR BONAMAT Chiller, Руководство по эксплуатации

Страница: 12 / 22

GB
version 1.0 E Copyright Bravilor Bonamat B.V.
3
3. INSTALLATION
READ! (700.403.347)
3.1 Unpacking
D
Verify that the device is complete. The contents of the packaging comprise:
− Chiller
− 1 drip − tray + grille
− 1 water filter
− 1 water − connection hose
− these operating instructions
D If components are missing or damaged, please contact your dealer.
3.2 Installation
CAUTION!
− Do not place the device with its back against
a heat source (i.e. heaters
).
− The device draws in air at the rear; therefore,
the ventilation grille at the rear may not be
covered. This also applies to the bottom side;
it must be possible to blow out the heated air
from this position.
D Connect the device to the water supply system
(drinking water) using an easily accessible
manually operated tap. Use the connection
hose supplied.
D Install the drip − tray in front of the device. Place
the fixing cams of the drip − tray in the locating
holes (fig. 1 , N.).
3.2.1 Connecting the drip − tray
to the drain (optional)
D Connect the drip − tray (fig. 1 , E) to the drain
with the aid of a drainage pipe. Drill a hole
through the drainage spout at the rear of the
drip − tray. It is easy to cut the drainage pipe to
the desired length and then slide this over the
drainage spout of the drip − tray.
CAUTION!
− Ensure that the drainage pipe lies flat.
3.2.2 Using the device the first
time
TIP
− The first time the device is used, it makes use
of the default factory settings. At a later date,
authorized personnel can change these
settings if required. See Chapter 6. for
information on this.
− The first time the device is used, it takes
approx. 30 minutes before the water has
reached the desired temperature.
D Activate the device by putting the plug into the
socket. The red triangle (fig. 1 , C1) and the
display (fig. 1 , C2) briefly light up. The display
then shows the temperature. The display
continues to flash until the set tempe4 C
is reached.
D Wait approx. 10 minutes until the reservoir has
filled.
D Deactivate the device by removing the plug from
the socket.
D
Use the draw − off tap (fig. 1 , G) to draw off
approx. 2 litres of water and throw this away.
D
Activate the device again by putting the plug into
the socket.
D Wait approx. 30 minutes until the display shows
the preset temperature of 6 C.
D The device is then ready for use, see Chapter 4.
D Now only remove the plug from the socket for
maintenance repairs.