If speaker No connect with cell phone . The software setting is :
When speaker
is on but
not
connected to a cell phone
(not in use ). There is no any beeps or sounds
until
the
speaker
has
not
been
in
use
for
29minutes
and
50
seconds.
then
there
are
3
beeps,
and
then
turn
off
immediately
.
If a 3.5mm cable or USB cable is incerted into the unit it will not enter power saving mode unless the battery is less than 3.2V
Note
：
This device complies with Part 15 of the FCC Rules:
Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference that is received, including any interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following tow conditions: (1)
this device may not cause interference, and
(2) this device must accept any interference, includinginterference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
