Brave VH1322GC, Руководство владельца/оператора и по безопасности

Страница: 13 / 48

Assembly Instructions
800-350-8739
11
Brave
5
. Lift the front leg and carefully roll the base
unit off the pallet.
6
. Carefully stand the rail assembly in an
upright, vertical position.
WARNING
Make sure the rail assembly is standing on
a flat, level area. If necessary, have a
helper steady the rail to prevent it from tip-
ping over. The rail assembly weighs
approximately 270 pounds and will cause
bodily injury if it falls on someone.
7 . Carefully align the base assembly, using
the front leg, with the rail assembly.
Have someone hold the rail
assembly to prevent it from falling
during this part of the assembly.
8
. Center the rail between the hinge plates
on the base assembly, as shown. Insert a
1/2-13 x 4-1/2 inch long hex head bolt
through rear top hole of the hinge plates
and rail. Install and tighten a 1/2-13
locknut.
NOTE:
To prevent the rail from binding,
do not over tighten the locknut. This
connection serves as the pivot point for
the log splitter from the vertical to
horizontal position.