Braun MULTIQUICK 3 K 600, Инструкция по установке и эксплуатации

Страница: 10 / 34

10
E
N
G
L
I
S
H
OPERATING INSTRUCTIONS
INSERTING SLIDES
Inserting a magazine
Push the slide transport arm fully into the scanner (Fig. 1) and insert the magazine
from the back until it touches the slide transport arm (Fig. 2). Make sure that the
magazine moves easily.
Make sure there are no objects next to the scanner for the slide transport arm to
extend fully (<10 cm).
Fig. 1 Fig. 2
Loading various magazines
Paximat round magazine
•
Pull out the slide transport arm fully.
•
Load the magazine from the top into the magazine tunnel so that the open side points to
the scanner. The inner ring shall contact the guiding pins.
Note: The round magazine shall be filled evenly with slides.
CS magazine
•
It is recommended to use the original CS system (reflecta, Braun) exclusively.
Other CS magazines or CS frames may lead to disturbances.
Universal magazine
•
Use only magazines with a DIN 108 label. Other magazines may lead to disturbances.
•
Pull out the slide transport arm fully.
•
Gently press the orange adapter on the slide transport arm. Move the adapter on the
slide transport arm to the front until it snaps in.
•
Push the slide transport arm back into the scanner.
•
Load the magazine from the back in the respective guiding rails of the magazine tunnel
until it hits the slide transport arm.
For all other magazines (except for the universal magazine described above), you
must return the adapter to its original position at the grip of the slide transport arm.
To release the adapter, gently press its outer tip.
Insert from the back