11
Manual cleaning
The hand-held unit shall be detached from the
power supply cord before cleaning. The shaver
shall not be used until it has dried.
Rinsing the shaving head under running water
is an alternative way to keep the shaver clean,
especially when travelling:
• Switch the shaver on (cordless)
w
and rinse
the shaving head under hot running water.
You may use liquid soap without abrasive
substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, press the release
button
9
to remove the Foil & Cutter cassette
8
and let it dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil on top of the Foil & Cutter
cassette.
Alternatively, you may clean the shaver using the
brush provided:
• Switch off the shaver. Remove the Foil & Cutter
cassette
8
and tap it out on a fl at surface.
Using the brush, clean the inner area of the
pivoting head. However, do not clean the
cassette with the brush as this may damage it.
Cleaning the housing
From time to time clean the housing of the
shaver and the Clean&Renew station with a
damp cloth, especially inside the cleaning
chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button
2
to open the
housing, wait for a few seconds before removing
the used cartridge to avoid any dripping.
Before discarding the used cartridge, make sure
to close the openings using the lid of the new
cartridge, since the used cartridge will contain
contaminated cleaning solution.
oil
trim
mer
er
release
trimmer
release
release
click!
Series 7
Series 7
Series
Series
oil
trim
mer
er
release
trimmer
release
release
click!
Series 7
Series 7
Series
Series
release
release
release
Series 7
Series 7
release
release
release
Series 7
Series 7
new
old
new
old
99503050_790cc_NA_Gift_S4-42.ind11 11
99503050_790cc_NA_Gift_S4-42.ind11 11
26.03.2010 8:25:01 Uhr
26.03.2010 8:25:01 Uhr