Braun 390CC-4, Быстрое руководство, Страница: 8 / 21

8
After you have replaced the Foil & Cutter
cassette (1), press the on/off switch (4) for
at least 5 seconds to reset the counter.
While doing so, the replacement light
blinks and goes off when the reset is
complete. The manual reset can be done
at any time.
Preserving the batteries
In order to maintain the optimum capacity
of the rechargeable batteries, the shaver
has to be fully discharged (by shaving)
every 6 months approximately. Then
recharge the shaver to full capacity.
Environmental notice
This product contains rechargeable
batteries. In the interest of pro-
tecting the environment, please do
not dispose of the product in the
household waste at the end of its useful
life. Disposal can take place at a Braun
Service Centre or at appropriate
collection sites provided in your country.
C Clean&Renew
Braun Clean&Renew has been developed
for cleaning, charging and storing your
shaver. Clean your shaver daily in the
Clean&Renew.
During the automated cleaning process,
the shaver is switched on and off at
intervals to obtain best cleaning results.
Since the specially formulated cleaning
fluid contains a small amount of oil,
the cleaning procedure also fulfils the
lubrication needs of the shaver.
Important
• Only use the power supply cord set
supplied with the shaver.
• In order to avoid any leakage of the
cleaning fluid, place the appliance on a
flat, stable surface. Do not tip, move
suddenly or transport in any way if a
cleaning cartridge is installed.
• Do not place the appliance in a mirror
cabinet, nor store it over radiators, nor
place it on polished or lacquered sur-
faces. Do not expose to direct sunlight.
• The appliance contains highly flam-
mable liquid. Keep it away from sources
of ignition. No smoking.
• Keep out of reach of children. Do not
refill cartridge. Use only original Braun
refill cartridge.
Description
1 Start/release button
2 Contact bow
3 Lift button for cartridge exchange
4 Level indicator
5 Cleaning cartridge
Before using Clean&Renew
Installing the cartridge
• Press the lift button (3) to open the
housing.
• Hold the cartridge down on a flat,
stable surface (e.g. table). Carefully
remove the lid from the cartridge. Slide
the cartridge into the base as far as it
will go.
• Slowly close the housing by pushing it
down until it locks.
Replacing the cartridge
After having pressed the lift button to
open the housing, wait for a few seconds
before removing the used cartridge.
Before discarding the used cartridge,
make sure to close the openings using
the lid of the new cartridge, since the
used cartridge will contain contaminated
cleaning solution.
The used cartridge can be disposed in
the household waste.
Operating your
Clean&Renew
• Connect your Clean&Renew with the
cord set to the mains electricity supply.
The special socket at the back is
adjustable to save space. After each
99781044_390cc_RUS_UA.indd 8 99781044_390cc_RUS_UA.indd 8 14.03.11 12:12 14.03.11 12:12