17
gnal dots and three keys whose functions are the following:
To operate the Defrost Timer proceed as follows:
8 OPERATION HELPFUL HINTS
1
Granita viscosity adjustment
: proper Granita viscosity is
factory preset. To change the viscosity, if needed, use a
standard screwdriver to turn the adjustment screw located in
the rear wall of each container as follows (see figure 4):
- towards right (clockwise) to obtain a thicker product (the indi-
cator F will go down in opening G).
- towards left (counterclockwise) to obtain a thinner product
(the indicator F will go up in opening G).
figure 4
2
Beverage temperature adjustment:
proper beverage
temperature is factory preset. To reset, turn the knob located in
each switch box as follows:
- towards right (clockwise) to decrease temperature.
- towards left (counterclockwise) to increase temperature.
Note: beverage temperature is controlled by the
thermostat only when the mixer/refrigeration switch(es)
are in I position, Soft Drink mode.
3
The length of time for freeze down of Granita is governed by
many variables, such as ambient temperature, mix initial
temperature, sugar content (Brix level) and viscosity setting.
4
To shorten Granita recovery time and increase productivity,
it is advisable to pre-chill the product to be used in the
dispenser.
5
To shorten Granita recovery time and increase productivity,
the bowl should be refilled after the product level drops lower
than half of the evaporator cylinder and at the start of each day.
6
For good product conservation the dispenser must run
overnight, at least in Soft Drink mode.
If this is not possible and product is left in the bowls overnight,
the mixer/refrigeration switches must be set to the I position at
least one hour before the unit is switched off. This eliminates
any block of iced product forming overnight, which could result
in damage to mixers or to their motor when the unit is switched
back on. In any case, before the unit is restarted, make sure
that no blocks of ice have been formed; if so, they are to be
removed before the unit is switched on. Overnight operation in
drink mode also eliminates possible ice accumulation from
condensation all around the bowls.
7
Mixers must not be turned off when frozen product is in the
bowl: if not agitated, the product may freeze to a solid block of
ice. If the mixers are turned back on in this situation, damage to
the mixers and their motor may result. Therefore, mixers may
be restarted only after product is melted.
8
The dispenser is equipped with a magnetic coupling by
which the gear motor (located outside the bowl) drives the
A Confirmation key
B Increase key
C Decrease key
D Seconds dots
E Granita/Day Mode dot
F PM dot
G Drink/Night Mode dot
H Defrost Timer ON/OFF dot
1
SET THE TIME OF THE DAY
Press keys A and B simultaneously to enter the Current
Time Setting Mode. Press keys B and C to set the
individual values and press key A to confirm and move on
to the next selection. The following values must be set:
a.European or American Time Mode: the value "24" or
"12" will flash on the display.
b.Setting of current hour: the first two digits will flash on
the display.
c.Setting of current minutes: the second two digits will
flash on the display.
Once finished the current time will be shown on the
display and the two dots (D) will flash.
If American Time Mode is selected dot F will be on during
post meridiem hours.
2
PROGRAM THE DEFROST TIMER
Press keys A and C simultaneously to enter the Defrost
Intervals Setting Mode. The setting will always start from
time 00:00 and Granita/Day Mode indicated by dot E.
Press keys B and C to increase or decrease the time by
intervals of 15 minutes and press key A to modify the
operating mode from Granita/Day, indicated by dot E, to
Soft Drink/Night, indicated by dot G, and vice versa.
To adjust the intervals, you must select whether the ma-
chine should be in Granita/Day or Drink/Night mode at
time 00:00 by pressing key A and then press key B until
you reach the time you want to change the operating mo-
de. Now press key A again to switch the mode and the
dots E or G will come on to indicate the selected mode. It
is possible to scroll backwards and forwards using keys
B and C to check the defrost time intervals. It is possible
to commute the operating mode every 15 minutes. In or-
der to exit the Defrost Intervals Setting Mode it is neces-
sary to set time 23:45 (11:45 PM), press key B and
message "end" will be shown on the display and then
press key A to confirm the exit.
3
TIMER ON/OFF
Once finished the programming, the Defrost Timer is still
deactivated and "----" is shown on the display. Press key
A for 3 seconds to activate the Defrost Timer and vice
versa. Dot H will indicate the state of the timer.
Note: when the Defrost Timer is deactivated the defrost
function is OFF (the machine operates as if it were not
equipped with Defrost Timer).
Содержание B-Frozen 10/1 Smart
Страница 52: ...02472 00500 R1 3 20C19...