5
3.2.2 When in use
ALWAYS
use manual power only.
ALWAYS
ensure two persons operate products of lifting capacities 3,2 – 10t when
loading them with loads approaching the nominal lifting capacity.
NEVER
use a product as a part for tensioning, pulling or anchoring loads.
NEVER
allow swinging the load, causing impacts or vibrations.
NEVER
load a product by diagonal pull.
NEVER
leave a suspended load without supervision.
NEVER
weld, cut or make any other operations on a suspended load.
3.2.3 After use
NEVER
leave a load suspended on the product.
ALWAYS
ensure the product against any incompetent use.
3.2.4 Risk analysis
The analysis of possible risks in light of design, operation and environment of the
product application is presented in freestanding document „Risk analysis“. This
document can be required in service centers.
3.2.5 Maintenance
ALWAYS
enable qualified persons to inspect the product regularly.
ALWAYS
ensure the sliding parts were greased enough.
Only such interventions can be done when maintaining the product that are in
compliance with requirements of the manufacturer specified in the chapters 10 and
13 of this manual.
IT IS NOT PERMITTED
to carry out repairs and maintenance in other way than
specified by the manufacturer. It concerns namely the forbiddance of using of
unoriginal spare parts or carrying out modifications on the product without any
approval of the manufacturer.
4 PACKING, STORAGE AND MANIPULATION
4.1 PACKING
4.1.1 Products of lifting capacity 1t are supplied assembled, packed into paperboard
boxes. Products of lifting capacities 1,6t, 3,2t 7,5t and 10t are supplied assembled in
bulk on pallets. The hand chain is ensured against unrolling by the wire.
4.1.2
The following accompanying documentation is a part of the delivery:
a) Operation Manual
b) EC Declaration of Conformity
c) Certificates of Quality and Completeness and Guarantee Card.
c1) Guarantee period is stated in the Guarantee Card.
c2) The guarantee does not apply to defects caused by infringement of the
instructions stated in this Operation Manual and defects occurred owing
to improper use and unskilled intervention.
c3) The guarantee does not apply also to modifications on the product or
using of unoriginal spare parts without an approval of the manufacturer.
c4)
A claim for defects in the product must be applied according to the
relevant provisions of the Commercial Code or the Civil Code, as
amended.
d)
List of service centers (for the Czech and Slovak Republics only).
