5
3.2.2 While operation
ALWAYS
make sure the load is properly placed on a cylinder.
ALWAYS
pay attention not to exceed maximum height of lift marked by the red
groove on a piston.
ALWAYS
after lifting a load ensure the piston of the cylinder by the nut.
ALWAYS
underlay load, if you intend to work on it.
ALWAYS
pay a special attention to a cylinder, if piston is released to maximum
position
(marked by the red groove on a piston).
NEVER
use cylinder for permanent underlying of loads.
NEVER
allow the load, causes impacts or vibrations.
3.2.3 After use
NEVER
leave lifted load without attendance and without ensuring the piston against
self downturn by the nut.
3.2.4 Risk analysis
The analysis of possible risk in turn of design, operation and environment of the
hydraulic cylinder application is mentioned in freestanding document “Risk analysis”.
This document can be required in service centres.
3.2.5 Maintenance
ALWAYS
let qualified personnel inspect the cylinder regularly.
Only such interventions can be done when maintaining that are in compliance with
requirements of the manufacturer specified in the chapter 13 of this manual.
It is not allowed
to provide repairs and maintenance in a different way then specified
by the manufacturer. It is especially prohibition of use of no original parts or providing
changes of product without the agreement of manufacturer.
4 PACKING, STORAGE AND MANIPULATION
4.1
PACKING
4.1.1 Cylinders are supplied assembled with hydraulic liquid, free loaded in transport
cases.
4.1.2 The following accompanying documentation is a part of the delivery:
a) Operation manual
b) EC Declaration of conformity
c) Certificates of Quality and Completeness and Guarantee Card
c1) Guarantee period is stated in the Guarantee Card.
c2) The guarantee does not apply to defects caused by infringement of the
instructions stated in this Operation Manual and defects occurred owing to
improper use and unskilled intervention.
c3) The guarantee does not apply also to any modifications on the product
without a written approval of the manufacturer.
c4) Claim of product defects is carried out according to applicable provisions
of commercial code eventually as amended.
