Brandt WTE1573D, Инструкция по эксплуатации

Страница: 4 / 16

16
EN
4
➀ ➁
1 2
➀
➀
➁
➁
➂
➂
➃
➃
➄
• Fill your machine to the maximum. You
thereby optimise your water and electricity
consumption.
• Only programme a pre-wash when
absolutely necessary: e.g. for heavily soiled
sports or working clothes, etc.
• A programme with no pre-wash is sufficient
for slightly or moderately soiled clothes.
• For slightly soiled clothes, select a short
washing cycle (or an «Express» cycle,
depending on the model).
• Gauge the amount of detergent according
to the water hardness, the degree of soiling
and the amount of washing. Always follow
the manufacturer’s instructions on the
detergent packets.
For washer-dryers:
• If you spin at high speed, little dampness
will remain and you will therefore consume
little electricity. Even synthetic textiles can
be spun before drying.
• Choosing your drying time well also helps to
save water and electricity.
• Avoid wasting water and electricity by not
over-drying your laundry.
Environment and savings
THE FOLLOWING OPERATIONS MUST BE
PERFORMED BEFORE YOU USE THE
MACHINE.
Figs 1 & 2
First of all remove the piece of expanded
polystyrene from under the lid. (Keep the
transport material: you will need it if you move).
Rear transport clamp
Fig. 1
➀
to
➃
➀
Unscrew the 6 screws using a No. 10 tube
spanner or a straight-edged screwdriver.
➁
Remove the clamp.
➂
Free the power cable from the plastic
holder clipping it to the transport clamp.
➃
Plug the holes left by the clamp using the
plugs supplied and re-screw the 4 external
screws into the casing.
Rear transport clamp Fig. 2
➀
to
➄
➀
Unclip the plinth by pressing simultaneously
on the side knobs and pulling them towards
you.
➁
Unscrew the screw holding the red plastic
«front» clamp.
➂
Remove the front clamp.
➃
Plug the hole left by the clamp with the
remaining plug.
➄
Clip the plinth on again.
Releasing your machine