Brandt WFH 1171 U, Руководство по эксплуатации

Страница: 7 / 24

5
G
2. Adjust feet until the appliance is level
and does not rock.
3. Important: Tighten all locking nuts af-
ter the machine has been levelled.
Connecting the water supply
This appliance can be connected to water
tabs with a 3/4" B.S.P. thread.
3
This appliance has a cold-water and a
hot-water inlet.
Important:
A
Always have both water inlet hoses
connected (cold and hot-water inlet
hose are different – note markings).
a) With cold and hot-water tap:
Connect hot-water tap to »HOT« and
cold-water tap to »COLD«.
b) Cold-water tap only:
Connect both inlet hoses with a Y-
tube to the water tap.
• Observe the permissible water pres-
sure and the max. inlet temperature
(see "Technical Specifications"). Install
a pressure reducing valve if the water
pressure is higher.
• Do not connect to a water heater (in-
stantaneous water heater or unpressu-
rised boiler), as the water pressure is
insufficient.
• Check with customer service for hose
extensions. Do not use homemade ex-
tensions with hose clamps or similar!
• Use only the new hoses supplied with
the machine, not old existing ones!
• Ensure that there are no sharp bends
in the hoses!
Required tools: None. (Do not use a pipe
wrench!)
HOT COLD
1. The offset side of the inlet hose is to
be screwed "finger-tight" to the water
inlet port at the rear of the appliance.
2. Connect the other end of the inlet
hose "finger-tight" to the water tap.
3. Open the water taps fully and check
all connections for tightness; close wa-
ter taps again. Correct the position of
seals and screw couplings, if neces-
sary.
A
For washing always both water taps
must be open (even if hereinafter it
says: open "water tap").
Connecting the drain hose
The drain hose can be fitted to a washba-
sin/sink or your bathtub.
3 It can also be permanently connected
to a syphon; leave this work to a quali-
fied plumber.
Important:
• Do not run the drain hose higher than
100 cm above floor level for the suds
pump to be able to pump out.
• The water must be able to run off un-
hindered. Washbasins with a small
drain are not suitable.
• The end of the hose must not im-
merge in the pumped-out water.
• Check with customer service for hose
extensions. Do not use homemade ex-
tensions with hose clamps or similar!
• Use only the new hose supplied with
the machine, not an old existing one!
• Ensure that there are no sharp bends
in the hose!