Brandt VS1010X, Инструкция по эксплуатации

Страница: 19 / 32

The cont rol pane l can be clea ned by using a lightly dampened cloth.
After cleaning, m ake sure to dry it thoroug hly.
For t he exterior, use a good appliance pol ish w ax.
Never use sharp objects, scouring pads or harsh cleaners on a ny part of the dishwasher.
Winterizing
1 .Cut off the electrical power to the dishwasher at the supply source.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain t he water from the inlet pipe and water valve. (Use a pan to gather the water)
4. Reconnect the water inlet pipe t o the water valve.
5. Remov e the filt er at the bottom of the tub and use a sponge to soak up water in the sump.
please take frost protection measures on t he dishwasher in winter. Every fter washing cycles,
please operate as follows
time a
：
Cleaning the Filter
Cleaning the Door
To clea n the coarse filte r an d the fine filt er, u se a clea ning brush. Rea ssem ble the filte r parts (see page 16)
and rei nsert the m in the dish was her, pos ition ing them in their sea t and pressing downw ards.
When cle anin g the filters, do no t kno ck them. Othe rwis e, th e filt ers could be c onto rted
and the p erfo rmance of the dish was her could be d ecre ase d.
To cle an the edge around the door,
To avoid pene tration o f water into the door lock and electrical components, do not
use a spray cleaner of any kind.
you sh ould only use a s oft, ward and damp
cloth.
Never u se a spr ay cleaner t o clean t he door panel as it m ay dam age the door loc k
and electrical components.
Abrasive ag ent s or som e paper towels shou ld not be used becau se of the risk of
scratching or leaving spots on the stainl ess steel surface.
Cleaning the Spray Arms
I f your dishwasher cannot work because of the ice,
please contact professional service persons.
I t is necessary to clean the spra y arm s re gularly fo r hard
w ate r che micals w ill clog the sp ray arm jets a nd bearings.
- After each cyc le, c heck for any deb ris in the filte r to avoid fut ure b lock age.
- By unscrew ing the coarse fi lter, you can rem ove the filter system . Re move any foo d remna nts and
clean the fi lters under runni ng water.
Remarks:
The entire filter assembly should be cleaned once a week.
To remove th e lower spray arm, pull out the spray arm u pwa rd.
To remove the up per spray arm, hold the nut, rotat e the arm
clockwise to remove i t.
Wash the arms in soapy and warm water and use a soft brush to
clean the jets. Replace them after rinsing them thoroughly.