Brandt TG1089XC, Руководство по установке

Страница: 2 / 22

2
INSTALLATION INSTRUCTIONS
DATA PLATE DETAILS:
The data plate is located on the front side of the tray.
According to the Gas Safety Regulations of Hong Kong, any gas installation
works including the installation of appliances and connection tubing, must be
undertaken by registered gas installers who are registered for that appropriate
classes and be employed by registered gas contractors.
CHECK THAT THE DATA PLATE SHOWS THAT THE APPLIANCE IS
SUITABLE FOR THE AVAILABLE GAS SUPPLY.
1. Before installing the appliance check that the location provides the required
clearances from combustible materials and if necessary provide protection to
adjacent surfaces as required by the regulations. Make provision for the gas
supply to be connected in the position shown in Diagram A.
Diagram A
Diagram B
Tray Dimensions (unit in mm) Cut out (unit in mm)
2. Cut the opening in the bench top to the dimensions shown in diagram B. The hob
must be built into the worktop of a support cupboard. This worktop must be at least 3
cm thick and heat-resistant or else coated with a heat resistant material. (Refer
Diagram C.) A side-clearance of at least 30 cm should be left to the right and left of
the hob. A tall cupboard or partition too close to the hob would hinder free movement
of kitchen utensils. If a horizontal partition is put under the hob, it must be placed
between 10 and 15 cm from the bottom of the worktop. In any case, do not keep any
sprays or pressurized containers in the compartment, which could be just under the
hob. Place the hob unit into the opening in the worktop by carefully pulling it
onwards you. Put the burners, caps and pan grates back into position.
Gas
supply