INSTALLATION INSTRUCTIONS
9002-8853 instructions 01-25-2017.docx
Page
4
of
5
GS
9.
Plug in the water proof camera connector into the power harness. Make sure the connector is going the
proper way and that it plugs in all the way.
10.
Route the harness away from any moving parts so the harness will not get cut. Enter the underhood
area and secure to the harness running along the driver’s side fender with zip ties.
11.
Route the camera harness into the vehicle's interior through the factory grommet in the firewall on the
driver’s side.
12.
Route the harness to the location of where the display will be.
13.
Connect the RED wire to 12 accessory power. Make sure to use a Digital MultiMeter to test for power.
14.
Connect the BLACK wire to a good clean ground.
15.
Plug the RCA end to the video display.
ADJUSTMENT OF CAMERA:
1.
To adjust the camera angle up and down, loosen the (4) 3mm Allen bolts on the side of the camera
mount to the bracket.
2.
There is 40º of angle up and down.
3.
As the camera angle changes check the display to see if is the correct viewing area.
4.
Adjust the angle up or down and retighten the (4) Allen bolts.
