INSTALLATION INSTRUCTIONS
9002-8853 instructions 01-25-2017.docx
Page
2
of
5
GS
Safety Precautions:
●
Work in well ventilated area that is clear of obstructions.
●
Secure vehicle with tire chucks in both front and rear of tires.
●
Turn vehicle accessories OFF and ensure ignition key is in OFF position.
●
Wear safety goggles and snug fitting clothes.
●
Use tools only for their intended purpose and which are in good repair.
●
Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
Mounting camera ABOVE the fairlead:
1.
Remove the fairlead from your front winch assembly and/or bumper.
2.
Position the front camera bracket so that its mounting holes line up with the mounting holes on your
fairlead. With the camera over the top of the fairlead.
3.
Before the bolts go back into the fairlead and camera mounting plate, apply Z-tech to the bolts holes and
anywhere on the back or side if any adjustments get made.(Later in install instructions.)
4.
Reattach the fairlead and front camera bracket to your front winch assembly and/or bumper with the
camera on top of fairlead.
5.
Plug in the water proof camera connector into the power harness. Make sure the connector is going the
proper way and that it plugs in all the way.
6.
Route the harness away from any moving parts so the harness will not get cut. Enter the underhood
area and secure to the harness running along the driver’s side fender with zip ties.
7.
Route the camera harness into the vehicle's interior through the factory grommet in the firewall on the
driver’s side.
8.
Route the harness to the location of where the display will be.
9.
Connect the RED wire to 12 accessory power. Make sure to use a Digital MultiMeter to test for power.
10.
Connect the BLACK wire to a good clean ground.
11.
Plug the RCA end to the video display.
