INSTALLATION INSTRUCTIONS
Step 24: Remove (2) 7mm bolts on both sides of the
steering column.
Step 25: Remove center stack/cluster surround.
Step 26: Remove glove box for access and run Chassis
Harness toward center of dash.
Step 27: Using a plastic trim removal tool, remove
HVAC panel.
Step 28: Connecting Power
Splice Red power wire to White/Grey reverse wire in
passenger kick panel (Engage parking brake and verify
reverse wire has 12v only when vehicle is in reverse).
Splice Black Ground to chassis ground. RECOMMENDED:
Use solder and cover with heat shrink tubing or use
T-taps as an alternate connection method.
Step 29: Plug the Chassis Harness RCA connector into
your aftermarket display.
Step 30: If you are using a factory display radio, you
will need to have the radio programmed at the
dealership for the back-up camera to display.
Step 31: Plug in the 22—pin white connector to the
open connector on the back of the radio.
Figure 1
Step 32: Connect White 22-pin Connector to radio
along with all remaining radio connectors before
reinstalling radio head unit and all trim removed.
Step 33: Connect male RCA of camera into female
RCA of jumper harness and proceed to the Dealer
Programming Instructions (Included).
9002-8848 Instructions 6-10-19
Page 6 of
7
KB
